Tools for this step:
Chop Saw
Carpenter Square
Tape measure
Welder (We used a stick welder)
Grinder
Materials for this step:
3/8" metal rod
Per section for this step:
48 - approx. 4" pieces (You will have to measure to be exact)
Welding Rods
Plywood Sheet from step1
Scrap pieces of board from step 1
Continuing on
Cut a template to the size of your photos with a piece of scrap board. Ours is 4X6. Use this to place between the vertical rods where you want your frames situated.
The vertical rods should all be equal at 4" apart, so you can cut pieces of rod to this length and weld them in place.
Picture of 4" pieces of rod. I did grind some on the edges just to take off some of the burrs.
The welding in progress.
Ours have the outside 2 sections mirror images of each other and the inside 2 sections are identical.
Here ends step 3. That was a lot of putsy work
wasn't it. It actually doesn't look so bad the way it is, but we don't want any grandkids getting their heads caught, so we'll be adding rods in between.
wasn't it. It actually doesn't look so bad the way it is, but we don't want any grandkids getting their heads caught, so we'll be adding rods in between.
Next Step, finishing up the vertical rods and hinges.





