Photo Room Divider Tutorial - Step 4

Tools for this step:

Chop Saw

Carpenter Square

Tape measure

Welder (We used a stick welder)

Grinder

Materials for this step:

3/8" metal rod 

        Per section for this step:

Various sizes (you have to measure)

Welding Rods

Plywood Sheet from step1

Scrap pieces of board from step 1

We're getting closer....

Now that all the frames are welded in, measure for the remaining vertical pieces between the frames, the top of section to top of frames and the bottom of section to bottom of frames. Cut these pieces and weld in place. 

We used a scrap piece of board top 

make a template, cut to the width of 

half  of one of the spaces. Be sure to 

always use the spacer on the same 

side to keep the spacing consistent, 

top to bottom.

Repeat for he remaining sections.

This is what we have so far. We didn't get to the hinges today, but hopefully tomorrow we will figure those out.

I know this seems like it is taking a

long time, but we have to work 

around our daily full time work.